Guide to Drawing decorative squares using Corel Draw 12

View: 532    Dowload: 0   Comment: 0   Post by: hanhga  
Author: none   Category: CorelDRAW Graphics   Fields: Other

9 point/2 review File has been tested

Select the rectangle drawing tool (Rectangle), draw a square the size of 10 cm by pressing Ctrl + left mouse click and drag the cross.

Introduction

In this exercise we use the drawing tool rectangle (Rectangle), circle (Ellipse) and some of the following commands:

- Tranfrom - Position: change objects in a precise location on the screen.

- Align and Distribute: to than their subjects.

- Trim: Create third object from two objects intersect.

- Combine (Ctrl + L): link object, the intersection of the objects will be created by the empty area.

- Break Curve Apart (Ctrl + K): Reimbursement an escape groups Combine command.

- Intersect: Creates third object, the intersection of two objects.

- Fill Tool: coloring tools.

- Outline Tool: tool contour.

Colouration:

- Select the rectangle drawing tool (Rectangle), draw a square the size of 10 cm by pressing Ctrl + left mouse click and drag the cross.

- On the Object properties bar in the cell (s) Size 10 cm type, in cells Nonproportional Scaling / Sizing Ratio padlock icon selected (blocking).

- Choose Object - Transformations - Position: Relative Position section in the middle and press the center select Apply To Duplicate card to add a second square is located on the first position of the image.

- Select tool to draw a circle (Ellipse) to draw a circle with a diameter of 10 cm.

- After drawing the circle is complete, select the circle and square.

- Choose Object - Align and Distribute:

Align Centers Horizontally

Align Centers Vertically

- Choose Object - Transformations - Position:

Relative Position: turn the box between the left edge, cell center of the bottom and middle of the right side box

Click Apply To Duplicate card (Figure 3).

- Choose 4 round and 1 square.

- Choose Object - Shaping - Trim (Figure 4).

- Turn to select 4 circle diameter reduced to 9 cm (Figure 5).

- Choose 4 circle.

- Choose Object - Transformations - Position:

Relative Position: in the center box

Click Apply To Duplicate card.

- In turn, select the newly created 4 circle diameter reduced to 7 cm.

- Just pick one big circle and 1 small circle with the same center, press Ctrl + L. I get one donut.

- Similar to the three remaining pairs of circle we added 3 donuts (Figure 6).

- In turn, select each donut and drew the first square.

- Choose Object - Shaping - Intersect: It was assigned 4 objects are part of 4 donuts and 1 square.

- Choose 4 donuts click Delete (Figure 7).

- Choose a square and a few objects like.

- Select tool Outline Tool - Outline Pen Line routing of the objects as you like.

- Select the object and color you like, we get the results shown in Figure 8.

Guide to Drawing decorative squares using Corel Draw 12

Guide to Drawing decorative squares using Corel Draw 12 Posted on 29-12-2015  Select the rectangle drawing tool (Rectangle), draw a square the size of 10 cm by pressing Ctrl + left mouse click and drag the cross. 4.5/10 532

Comment:

To comment you must be logged in members.

Files with category

 

File suggestion for you

File top downloads

logo codetitle
Codetitle.com - library source code to share, download the file to the community
Copyright © 2015. All rights reserved. codetitle.com Develope by Vinagon .Ltd